wifiwart

The WiFiWart is an open source WiFi penetration device masquerading as a regular wall charger. It features a 1.2Ghz Cortex A7 MPU with two WiFi chips onboard. The electrical, mechanical and software is all completely open source. The elec is design in Kicad, hardware in FreeCAD and software will be all GNU/Linux based. Eventually there will be three PCBs in this repository. Rather than placing redundant information in this file, I would encourage readers to check out the blog series listed below for a very in depth walk through.

Repository Structure.

.
|-- electronics
|   |-- app_notes
|   |-- datasheets             # Datasheets of the parts used
|   |-- nff_comp_pcb           # "Non-Form-Factor" build
|   |   |-- generate_bom.py    # This is used to generate the bom
|   |   |-- gpio.sch
|   |   |-- hardware-cache.lib
|   |   |-- hardware.kicad_pcb
|   |   |-- hardware.pro
|   |   |-- hardware.sch
|   |   |-- R0.1                # First Revision Build files
|   |   |-- Renders             # Pics of the board
|   |   |-- replace.sh          # Don't run this
|   |   |-- step             
|   |   |-- sym-lib-table
|   |   `-- ti
|   `-- scripts
|       |-- crystal_caps.m
|       |-- psu_current.m
|       `-- psu_resistor.m
|-- LICENSE
|-- mech                         # Mechanical Design
|   |-- case.FCStd
|   |-- lid.FCStd
|   |-- prong.FCStd
|   `-- refs
|-- notes
|-- plan
|   |-- gantt.tex
|   |-- Makefile
|   `-- notes
`-- readme.md